 | | | | | | |
|  |  | ||||
|  | |||||
|  |  |  |
 |
 |
|
|  |  |  |  | ||
Originally the Flying Cloud had a 110 volt fan over the stove, and a 110volt swamp cooler in the center vent hole. The renovation plan calls for replacing the stove vent fan with a 12volt motor, and the swamp cooler with a 12v Fantastic Fan.
The old Hehr shroud is removed by drilling out all the rivets
The inside of the vent opening before the old shroud is removed
The 50 year old sealant is seen here, not bad shape, but some others I've seen all dried out - and can be a source of leaks
The Fantastic Fan installed
Full open. Those are the solar panel electrical studs fore & aft
Comparison to the older vents
Viewed from the ground
Plastic FF vent lid hinges forward
Finished installation using the original vent trim
I reused the original LeDuex knobs in place of the plastic knobs
I cut the shaft off the original knobs and used a set screw to secure
Finished installation, blended in by using the Zolatone
- click on any image to enlarge -
- click on any image to enlarge -
You can get the best deal on the Fantastic Fans, and get the correct shaped cover from Vintage Trailer Supplies
